Totalling - Ravas 1100 Manual Del Usuario

The weighing system is loaded: press the PT key for two seconds. The tare value is set

to zero and the system returns to the standard weighing mode.
Or
The weighing system is unloaded: press the

the system returns to the standard weighing mode.
3.6. Totalling
The indicator offers the possibility to add up weighings and show the total weight. When a tare
weight is active, the net weight is added up automatically.
Load the system with the weight that should be added.

Press the key to add the weighed load to the total weight.
 Σ
The value of the display is stored and added in the memory.

In turn, the indicator shows the sequence number (number of weighings) and the

(sub)total.
If the weighing system has been equipped with a printer, the value shown is printed at the

same time.
After a few seconds the system will automatically return to the standard weighing mode.

Or
Press the Σ key for three seconds to refer to the total weight calculated thus far (without

totalling).
In turn, the indicator shows the sequence number (number of weighings) and the

(sub)total current in the memory.
After a few seconds the system will automatically return to the standard weighing mode.

The memory can be erased by pressing the

If the system is equipped with a printer, an overview print is made.

The display shows sequence number 00 and the total weight 0.0 kg.

The system will automatically return to the standard weighing mode.

key during the display of the total.
Σ
‐ 11 ‐
0/T key. The tare value is set to zero and
 