Makita DHG180 Manual De Instrucciones página 9

Wide-slot nozzle Heat packaging for heat shrink films
For heating spread
over wider area
Reflector nozzle Heat shrinking for heat shrink tubes
Bending of resin tube
Reduction nozzle Paint stripping with the scraper (optional
For heating concen- accessory)
trated over small
area
Overlap welding Patching a vinyl sheet with the pressure
nozzle roller (optional accessory)
(Optional
accessory)
Solder sleeves Heat shrinking for heat shrink tubes
reflector
(Optional
accessory)
Welding nozzle For heating concentrated over small
(Optional area
accessory)
WARNING:
Ensure the power tool is switched
off and battery cartridge is removed from the
power tool before attaching the accessories.
Attaching the accessories with switch on or battery
cartridge attached may cause the risk of accidents.
WARNING:
Make sure to attach the accesso-
ries securely. Otherwise the accessory may fall off
accidently and cause burn injury.
Detaching the accessory
Turn the front cover in the direction of the arrow in the
illustration, the accessory will be ejected. This allows
you to remove nozzles without touching them while they
are still hot.
► Fig.2
WARNING:
Do not touch the accessory
attached to or ejected from the heat gun imme-
diately after use. Do not eject the accessory to
any person or animal. The nozzle attachment gets
extremely hot after use and cause risk burn injury.
WARNING:
Do not eject the accessory to any
surface that is flammable or easy to be melt. The
nozzle attachment gets extremely hot after use and
cause risk of fire or melting the surface.
WARNING:
Use the identical accessories
included in the original package or serviced by
the dealer or service center. Use wrong or defective
accessory may cause the hot air to flow backward
and damage the tool and create a hazard.
Installing or removing battery
cartridge
CAUTION:
Always switch off the tool before
installing or removing of the battery cartridge.
CAUTION:
Hold the tool and the battery car-
tridge firmly when installing or removing battery
cartridge. Failure to hold the tool and the battery
cartridge firmly may cause them to slip off your hands
and result in damage to the tool and battery cartridge
and a personal injury.
► Fig.3: 1. Red indicator 2. Button 3. Battery cartridge
To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator as
shown in the figure, it is not locked completely.
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
it may accidentally fall out of the tool, causing injury to
you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
9 ENGLISH