Intended Use - Hilti SL 6-22 Manual De Instrucciones Original

3 Description
3.1 Product overview
Lamp head
@
LEDs
;
Vertical pivot joint
=
Installation opening for acces-
%
sories
Battery
&
Mode switch (light intensity)
(

3.2 Intended use

The product described is a cordless floodlight. It is used for lighting up
jobsites.
The lamp head can be pivoted horizontally and vertically. Additionally, the
light can be set on a flat surface, suspended from various construction
materials by means of the integral hook, or mounted on a tripod with 5/8"
thread.
For this product, use only Hilti Nuron lithium-ion batteries of the B 22
•
series. For optimum performance, Hilti recommends the batteries stated
in the table at the end of these operating instructions for this product.
For these batteries, use only Hilti chargers of the type series stated in
•
the table at the end of these operating instructions.
3.3 Items supplied
Cordless lamp, operating instructions.
Other system products approved for use with this product can be found at
your local Hilti Store or at: www.hilti.group
3.4 Status indicators of the Li­ion battery
Hilti Nuron Li-ion batteries can indicate state of charge, fault messages and
the battery's state of health.
3.4.1 Indicators for state of charge and fault messages
WARNING
Risk of injury by a falling battery!
▶ If the release button is pressed with a battery inserted in the product,
subsequently check that the battery is correctly re-engaged and secure.
Short-press the release button of the battery to get whichever of the following
status indications is applicable at the time.
State of charge and, if applicable, faults are indicated constantly as long as
the connected product is switched on.
*2266228*
1
)
+
§
/
:
∙
$
2266228
Locking switch, vertical
Heat sink
Carrying handle
5/8" thread for tripod mount
Suspension/attachment hook
Battery release button
Battery status indicator
English 5