Intended Use - Hilti SFL 14-A Manual De Instrucciones Original

▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not disassemble, squash or incinerate batteries and do not subject
them to temperatures over 80°C (176°F).
▶ Do not attempt to charge or continue to use damaged batteries.
▶ If the battery is too hot to touch it may be defective. In this case, place
the appliance in a non-flammable location, well away from flammable
materials, where it can be kept under observation and allowed to cool
down. Contact Hilti Service after the battery has cooled down.
▶ Use only the specified batteries in the product.
3 Description
3.1 Overview of the product
Reflector
@
Lamp body
;
Control knob
=

3.2 Intended use

The product described is a cordless lamp. It is designed to be used to
illuminate areas of jobsites. Use the product in a dry environment only.
▶ Use this product only with Hilti Li­ion batteries of the B 14, B 22 and B 36
series.
▶ Use only Hilti battery chargers of the C4/36 series for charging these
batteries.
3.3 Items supplied
Cordless lamp, operating instructions.
Other system products approved for use with this product can be found at
your local Hilti Center or online at: www.hilti.com
3.4 State of charge display
The charge state of the Li­ion battery is displayed after pressing one of the
two battery release buttons lightly (press only until slight resistance is felt).
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks.
Note
If the battery charge state LEDs blink, please refer to the information
given in the Troubleshooting section.
Printed: 26.10.2016 | Doc-Nr: PUB / 5071526 / 000 / 09
1
On/off switch
%
Strap attachment point
&
Battery
(
Meaning
• Charge state: 75 % to 100 %
• Charge state: 50 % to 75 %
• Charge state: 25 % to 50 %
• Charge state: 10 % to 25 %
• Charge state: < 10 %
English 11