Filling Instructions - DeVilbiss 9100D Guía De Instrucciones

4
The DeVilbiss Model 9100D Humidifier will produce the
following humidification levels at the flow rate shown
under ambient conditions of 72°F (22°C) and approxi-
mately 50% relative humidity.
Flow Rate(L/Min) Relative Humidity @72° F(22°C)
30
60
85
At the extreme condition of minimum water level and
dry ambient air (104°F/40°C, 5% R.H), the DeVilbiss
Humidifier will provide approximately 25% R.H. at the
nasal mask.

FILLING INSTRUCTIONS

CAUTION –Use only fresh distilled or sterilized water
that is at room temperature. Do not add any
medication or other additives to the water.
Ensure that all six slide latches are positioned in the
locked ( ) position and that the o-ring seal is prop-
erly positioned. Hold the humidifier vertical with the
inlet and discharge ports facing upward. Pour enough
water in both ports (Figure 2) until the water level in
both halves of the chamber is between the minimum
and maximum fill lines on the top surface of the
humidifier lid. The water level must be between the fill
lines across the entire length of the lines (Figure 3).
The humidifier can also be filled by adding a pre-mea-
sured amount of water, between 425ml and 525ml, into
both ports.
Before each use, ensure that the humidifier is clean
(reference Care and Cleaning Instructions) and filled to
the appropriate level with fresh distilled or sterilized
water that is at room temperature.
A-9100
All manuals and user guides at all-guides.com
64
58
66
F i l l i n g I n s t r u c t i o n s
Figure 2
Water Level
Figure 3