Rupes RP84 Manual página 6

MAINTENANCE
All maintenance operations are carried out with the power supply disconnected.
At the end of each work session, or when required, remove any dust using
a jet of compressed air paying the dust filter and particular attention to the
motor ventilation slots.
No other maintenance operations must be undertaken by the user.
Maintenance and cleaning of the inner parts, like brushes, ball bearings,
gears etc. or others, must be carried out only by an authorized customer-
service workshop.
ELECTRIC SAFETY - LOW TENSION
The tests have been carried out in accordance with the standard:
EN 60745-1 safety of hand-held electric motor operated tools
EN 60745-2-15 particular requirements for edge trimmers.
RADIO SUPPRESSION
The tools are suppressed in accordance for the prevention and elimina-
tion of radio disturbances measured in accordance with standard:
EN55014-1+EN55014-2; EN61000-3-2+EN61000-3-3.
NOISE
The noise level, produced by the machine in normal working conditions at
the work station is 84,5 dB (A) measured according to regulation EN ISO
3744 + UNI EN ISO 11202.
Warning: wear suitable hearing protections! (see warnings).
MEAN ACCELERATION VALUE
The mean quadratic acceleration value is less than 2,5 m/sec 2 measured
in accordance with standard UNI EN28662 + UNI EN ISO 5349.
10