Rupes RP84 Manual página 7

GUARANTEE
All tools manufactured by RUPES Spa are guaranteed for 12 months from the date of pur-
chase against fabrication and material defects.
All tools must be used only with RUPES original accessories and spare parts: we refuse all
responsibility for damages or accidents caused by non-observance of this rule which will
also cause the termination of the guarantee.
The guarantee will no longer be valid if the instructions contained in this booklet are not
followed, if the tool is used for purposes other than that for which it is intended, if it is di-
smantled, interfered with in any way or damaged due to neglect.
TOOL IDENTIFICATION PLATE
POSITION AND MEANING OF INFORMATION
1. Type of tool.
2. Nominal working voltage in Volts (V).
3. Working frequency in Hertz (Hz).
4. Absorbed current in Amperes (A). Ensure that the power supply to which the tool is
connected can easily tolerate the indicated current as a minimum.
5. Absorbed power expressed in Watts (W).
6. Tool code or serial number.
7. Technical data of the tool.
8. Maximum rpm
9. The double square indicates that the tool is doubly insulated and therefore does
not require earthing through the power supply cable.
10. Read all these instructions before operating this product and save these
instructions.
11. Personal safety devices.
12. At the end of its useful life, the product, pursuant to European Directive
2002/96/CE (RAEE) + 2003/108/CE and its implementation in national law, must
not be released into the environment or thrown away as domestic waste, but must
be disposed of at authorised recycling centres (contact the relevant local
authorities for a list of places where the product may be disposed of according to
the law).Disposing of the product correctly contributes to protecting human health
and safeguarding the environment. Any illegitimate disposal of the product will be
punishable by law.
The guarantee will be made valid by filling-in the form on the inside back cover of
this instruction booklet.
If the tool is found to be defective or malfunctions, it should be returned carriage free in
one piece in its original packing together with the guarantee certificate to the manufacturer
or to one of the Assistance Centres listed in the appendix to this booklet.
The guarantee does not automatically imply replacement of the tool.
RUPES Spa reserves the right to make any technical or design modification to its pro-
ducts without prior notice. The manufacturer is not liable for any print errors. This do-
cument voids and replaces previous ones.
CONFORMITY DECLARATION
Year of affixing to the mark: 96
We declare on our responsibility that the represented hand-held electric
motor operated tool, in protection class II, is in conformity with the
Essential Requirements of Safety of the following Directives:
2006/42/CE Machinery
2006/95/CE Low Tension
2004/108/CE Electromagnetic Compatibility
The tests have been carried out in accordance with following Standards:
EN ISO 12100: 2010 Safety of machinery – General principles for design
– Risk assessment and risk reduction
EN 60745-1:2008 Safety of hand-held electric motor operated tools
EN 60745-2-15: 2009 Particular requirements for edge trimmers
UNI EN ISO 3744:1997 Acoustics. Determination of sound power levels
of noise sources.
UNI EN ISO 11202: 1997 Acoustics. Noise emitted by machinery and
equipment.
UNI EN 28662-1: 1993 Hand-held portable power tools. Measurement of
vibrations at the handle.
UNI EN ISO 5349-1: 2004 Mechanical vibration. Measurement and eva-
luation of human exposure to hand-transmitted vibration.
Electromagnetic compatibility:
EN 55014-1: 2008 + EN 55014-2: 1998
EN 61000-3-2: 2009 + EN61000-3-3: 2008
Electromagnetic fields:
EN 62233: 2008
S.p.A
IL PRESIDENTE
G. Valentini
11