Making Tea With A Tea Lid - GRAFF WK350 Manual De Instrucciones

fill-level marking. The water would bubble over when boiling.
Place the lid back on. Check to see that it audibly locks into place.
●
Place the electric kettle onto the base station and switch on the unit by touching the
●
symbol.
Touch on the desired temperature.
●
Temperature selection
80 °C
70 °C
60 °C
1 beep will sound, with the LED ring illuminating blue.
IMPORTANT!
Make sure that the maximum fill mark is not exceeded. Fill the unit so that the water level is
between the minimum and the maximum fill-level marking. Burns / scalding may be caused
by effervescent water.
During the heat-up process the set temperature will be continuously flashing and the under-
●
lying temperatures will light up when being reached.
Once the desired temperature has been reached, 2 beeps will sound. The illuminated LED
●
ring will go out.
The unit will switch off after approx. 1 minute unless the warm-keeping function has been
●
selected.
Remove the unit from the base station.
●
Slowly pout the water into a cup or similar container.
●
Put the unit back onto the base station.
●

MAKING TEA WITH A TEA LID

Take the base station and wind up the cable as far as possible. The length of the supply line
●
which is not necessary can be wound up at the bottom of the base station.
Insert the plug into the socket.
●
Remove the lid.
●
Fill the electric kettle with a minimum of 0.5 litre of water. Do not exceed the
●
maximum fill-level marking. The water would bubble over when boiling.
Place the electric kettle on to the base station.
●
Ideal for:
all black teas, herbal and fruit tea mixtures
hand-brewed filter coffee, approx. 93° C
all green tea types and instant drinks, 80 °C
green and white teas, 70 °C
Japanese green tea, 60 °C
DE
EN
FR
NL
IT
ES
DK
SE
NO
PL
HU
UKR
25