Important Safety Instructions; Intended Use - Tripp-Lite AG-05D9 Serie Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1 Overview & Safety Instructions

1.1 Important Safety Instructions

Intended Use

• The unit serves as a single-phase line-interactive uninterruptible power supply (UPS) for its connected loads.
• Do not connect laser printers or scanners to the UPS. This may cause damage to the unit.
• The UPS is not for use in a computer room as defined in the Standard for the Protection of Electronic Computer/Data
Processing Equipment ANSI/NFPA 75
• The UPS is available in 700/750/1000/1500VA models. Each model has internal batteries.
• The UPS can be used to power computers and associated peripheral devices, such as monitors, modems, cartridge tape
drives, external hard drives, etc.
• Handling: Transport the unit only in suitable packaging to protect it from jolts and shocks. The UPS must be kept upright at
all times and handled with care.
Placement & Installation Warnings
• Install the UPS in a well-ventilated area, away from extreme temperatures, excess moisture, heat, dust, flammable gas or
explosives.
• Leave at least 4 inches (15 cm) of space in the front and at the rear of the UPS for proper ventilation.
• Electrical maintenance and service requires access to the front and back of the UPS. Leave the necessary space to allow
service personnel access to the UPS.
• US installations only: The UPS is not for use in a computer room as defined in the Protection of Information Technology
Equipment ANSI/NFPA 75. Contact Tripp Lite Support for assistance.
• The UPS can be installed vertically (tower mounting) or horizontally (rack mounting) according to the user's desired
arrangement. Please observe the following:
• Do not mount the UPS with its front or rear panel facing down at any angle.
• Keep the UPS upright at all times and handle it with care.
• Do not stack the units.
• Do not place any objects on the UPS or any other accessory associated with the UPS.
• Install the UPS on a level and even surface.
• For tower-mounting installation, ensure that your chosen location's floor can bear the weight of the UPS and tower stands
(optional).
• For rack-mounting installation, make sure your chosen cabinet can support the weight of the UPS and the rails that may be
mounted in an associated rack. You also need to take your chosen location's floor weight loading into consideration.
• For rack-mounting installation, do not let your rack become "top heavy".
• Install the heaviest equipment near the bottom of the rack.
• For weight information about the UPS, please refer to section 12 Technical Specifications.
• Install the UPS in accordance with the conditions as specified in section 3.1 Installation Data.
• To reduce the risk of electric shock, install the UPS in a temperature and humidity controlled indoor area free of conductive
contaminants.
• The operating temperature is at 32°F~104°F (0°C~40°C).
4

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido