Tower-Mount Installation - Tripp-Lite AG-05D9 Serie Manual Del Propietário

3 Installation
2
Connect the two segments of each rail
the included screws and nuts
slightly loose so that the rails can be adjusted in the
next step.
3
Adjust each rail to fit your rack, then mount them
in the lowest available space of your rack with the
screws, nuts and rail mount plates provided
that the support ledges should face inward. Tighten
the screws that connect the rail segments
4
Insert the UPS into the rack and tighten the four
provided screws.

3.3 Tower-Mount Installation

Notes:
• Use the included hardware to mount the UPS models
in an upright tower position.
• The user must determine the fitness of hardware and
procedures before mounting.
1
Stand your UPS on its side with the LED display facing
the top. Using the included screws, attach a
rack mounting ear to each side of the UPS.
using
A
B . Leave the screws
C . Note
.
B
B
A
2
3
4
19
C
B