Connecting And Linking The Rdnet Signal - dB Technologies VIO S115 Manual De Uso

CONNECTING AND LINKING THE RDNET SIGNAL

•
To enable remote control, connect the DATA IN (A) of the first subwoofer to the remote
controller (RDNet Control 2 or RDNet Control 8) using cables fitted with etherCON®
connectors.
•
Link the signal by connecting DATA OUT (B) on the first subwoofer to DATA IN (C) on the next
subwoofer, and so on.
•
When the subwoofers are powered on, the Link LEDs will illuminate to indicate the
connection has been made. The other Active LEDs will start flashing to indicate the presence
of data traffic.
CAUTION!
•
To prevent malfunction or poor sound quality, replace any damaged cables.
VIO S115
32
SUBWOOFER 1 SUBWOOFER 2
Cod. 420120357 REV. 1.0
English