Electrical Connection - universalblue UECGDWHITE-19 Manual De Instrucciones

CONNECTION TO NON-FLEXIBLE TUBE
(copper or steel)
Connection to the gas source must be done in such a way as to not create any stress
points at any part of the gas hob.
The hob is fitted with an adjustable "L" shape connector and a gasket to the gas
supply.
The connector should be dismounted and the gasket must be replaced.
The feeding connector of the gas to the hob is threaded 1/2 gas cylinder.
CONNECTION TO FLEXIBLE STEEL TUBE
The gas feed connector to the hob is threaded, 1/2" connector for round gas pipe. Only
use pipes and sealing gaskets that conform to the standards currently in force. The
maximum length of the flexible pipes must not exceed 2000 mm. Once the connection
has been made, ensure that the flexible metal tube does not touch any moving parts
and not be crushed.
Check the Seal
Once the hob was installed, make sure all the connections are properly sealed, use a
soapy water to test, never use flame.

ELECTRICAL CONNECTION

The hob fitted with a tripolar electrical supply cord which are designed to be used
alternating current. According to the indications on the rating plate located under the
hob. The earthing wire can be identified by its yellow-green colour.
In the case of installation over a built-in electric oven, the electrical connections for the
hob and oven should be independent, not only for safe purpose, but also be convenient
to remove them in the future.
ELECTRICAL CONNECTION FOR GAS HOB
Fit the supply cord with a standard plug for the demand rate indicated on the rating
plate or connect it directly to the electrical mains. In the latter case, a single pole
switch must be placed between the hob and the mains, with a minimum opening
between the contacts of 3 mm in compliance with current safety codes (the earthing
wire must not be interrupted by the switch). The power supply cord must be positioned
so that it does not reach a temperature in excess of 50℃ than room temperature at
any point.
31