General Safety Instructions - Bosch Rexroth NEXO Serie Manual Del Usuario

Nexo | 36088703D0/2014-04
Qualified personnel:
• are those who are able to assess the tasks they are commissioned to perform, identify possible risks
and take the appropriate safety measures due to their professional training, knowledge, and experience
as well as their knowledge of the applicable regulations;
• must observe the rules relevant to the subject area;
• must be trained, instructed, and authorized to switch electrical circuits and devices on and off in
accordance with the accepted rules of safety engineering, ground them, and appropriately label them
according to job requirements;
• must be sufficiently familiar with all warnings and precautions according to this documentation and the
documentation of the respective component and understand their content;
• must have appropriate safety equipment and be trained in first aid.
2.5

General safety instructions

Damage to persons and property.









2.6
In this chapter, general safety instructions are listed that relate to the technology used in the product.
Use and handling
of the electric tool
Improper handling!
Damage to persons and property.




LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
General safety instructions
Observe the applicable accident prevention and environmental protection regulations.
Observe the safety regulations of the country in which the product is used/operated.
Use Rexroth products only when they are in good technical order and condition.
Observe all notes on the product.
Persons who assemble, operate, disassemble, or maintain products by Bosch Rexroth AG must
not be under the influence of alcohol, drugs, or pharmaceuticals that may affect their ability to
respond.
Only use accessories and spare parts approved by the manufacturer to prevent danger to persons
due to unsuitable spare parts.
Observe the technical data and ambient conditions specified in the product documentation.
If unsuitable products are installed or used in safety-relevant applications, unintended operating
states may occur in the application that may cause personal injuries and/or damage to property.
Therefore only use a product in safety applications if this use is explicitly specified and permitted in
the product documentation.
You may only commission the product if it has been determined that the end product (e.g.,
machinery or a system) in which the Rexroth products are installed complies with the country-
specific provisions, safety regulations and standards of the application.
Product- and technology-dependent safety instructions
Keep the electric tool away from rain or moisture. Water penetrating into the electric tool will
increase the risk of electric shocks.
Secure the workpiece. A workpiece that is held by clamping devices or a vise is held more safely
than if it is held by hand.
Hold the electric tool firmly and do not clamp it in a vise. When tightening and loosening screws,
high reaction torques may occur for short periods of time.
Do not expose the electric tool to inadmissible mechanical loads under any circumstances. Never
use the electric tool as a lever or hammer. Do not place any objects on it.
Bosch Rexroth AG
CAUTION
CAUTION
27/264
Betriebsanleitung | AB