Troubleshooting - SOLAC HU1050 Instrucciones De Uso

Libro HU1050.book Page 13 Monday, September 10, 2007 10:45 AM

Water must not get into the appliance; should this happen, take it to an
authorised service centre before using it again.

5 TROUBLESHOOTING

P P
ROBLEM OSSIBLE CAUSE
The The humidifier is not
appliance connected to the mains.
is not
The power socket is not
receiving
receiving power.
power
The water tank is empty
(1).
No mist
The fan is broken.
comes
out
Some other component
of the appliance is
broken.
The selected moisture
output level is too low.
The appliance is not
No mist
placed on a flat surface.
comes
out but There are scale deposits
the water on the transducer.
tank is
Detergent was used to
full.
clean the tank.
The transducer is broken.
Scale Hard water with high
deposits mineral content
Water in the tank for too
Bad smell
long.
6 OBSERVATIONS

Humidifiers using ultrasound technology produce smaller water particles
which can more easily reach the lower respiratory tracts.
This type of humidifier is therefore suitable for the treatment of
symptoms of the common cold and laryngitis.
TROUBLESHOOTING
S
UGGESTION
Plug the appliance into the mains.
Check the fuses and whether or
not the socket is receiving power.
Fill the water tank.
Call the authorised technical
service.
Call the authorised technical
service.
Select a higher moisture output
level.
Place the appliance on a flat
surface.
Clean the transducer using the
included brush and fill the tank
Rinse the tank with clean water.
Call the authorised technical
service.
Use distilled water.
Clean the tank with water and
vinegar and rinse with clean water.
Leave the tank open for some time
without the cap, in a cool place.
en
13