Publicidad
Step 4
Separate the EXTENSION SLIDES (HH) from the
å
EXTENSION RAILS (GG) as shown in the upper diagram.
Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (GG) to the ENDS (A and B).
å
Use four GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into
å
the hole shown in the enlarged diagram. Then, slide the
inner cartridge of the EXTENSION RAIL out to fi nd the
other hole that lines up with the hole in the END. Turn a
SCREW into this hole.
Push the black lever in and pull the SLIDE from the RAIL.
Finished edge
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
www.sauder.com/services
HH
B
Open end
3S
A
GG
418648
GG
Finished edge
Open end
GG
Page 9
Publicidad
