Status
4 LEDs blink, the power tool is not
ready for use.
Battery charge state cannot be displayed while the control switch is
pressed and for up to 5 seconds after releasing the control switch. If
the battery display LEDs blink, please observe the instructions given in
the Troubleshooting section.
3.4 Items supplied
Drill / driver, operating instructions.
•
Other system products approved for use with this product can be found
at your local Hilti Store or at: www.hilti.group
4
Technical data
4.1 Drill/driver
Rated voltage
Weight including battery B22⁄8.0
Speed
Torque (soft joint)
Torque range (15 settings)
Ø drill bit (metal)
Ø drill bit (hardwood)
Ø drill bit (softwood)
5
Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or
before changing accessories.
Observe the safety instructions and warnings in this documentation and on
the product.
*2184702*
Meaning
The power tool is overloaded or has
overheated.
2184702
21.6 V
6.8 lb
1st gear
0 /min ...
370 /min
2nd gear
0 /min ...
2,140 /min
≤ 37 ftlb
1 ftlb
1/16 in ... 1/2 in
1/16 in ... 3/4 in
1/16 in ...
1 1/4 in
f
... 9 ftlb
f
f
English
9