Adjusting Video Settings - Dynabook PA5356E-1PRP Manual Del Usuario

dynabook USB-C™ Dock

Adjusting Video Settings

1. Right-click on the desktop and select Intel
open the Intel
2. Click Display.
This section only introduces some general settings. For more information,
NOTE
go through the on-screen options to choose the one as desired.
General Settings
■
Resolution: Change the resolution setting of the external monitor
connected to the dock. Be sure to select one of the supported resolution
numbers in the table above. For an external monitor, you can also
select any resolution supported by that monitor.
Refresh Rate: Be sure to select a refresh rate that is supported for the
resolutions and color depth settings, as indicated in the table above.
Scaling: Select the screen scaling for the external monitor connected
to the dock.
Some of these settings are also provided on the Windows
NOTE
Settings screen. To access it, right-click on the desktop and click Display
settings.
Resolution: click Advanced display settings and select the desired
resolution from the drop-down list.
Refresh Rate: click Advanced display settings -> Display adapter
properties -> Monitor.
If you use multiple docks with a single computer, for example, one at work
place and one at home, the video settings for each dock are saved when
you disconnect the computer. This enables you to have your dock set up
with different video settings for different locations. The settings are retained
each time you use the dock with your computer.
Multiple Displays
■
The Intel
displays. Select your preferred Display Mode (Single Display, Clone
Displays, and Extended Desktop) on the Multiple Displays screen. You are
also allowed to select one ore more active displays here.
Only a maximum of three monitors will be displayed under Multiple
NOTE
Displays even more than three monitors are connected.
EN-22
®
HD Graphics Control Panel.
®
HD Graphics Control Panel allows you to configure multiple
®
Graphics Control Panel to
®
Display
User's Manual