Working Environment; Canadian Notice - Dynabook PA5356E-1PRP Manual Del Usuario

dynabook USB-C™ Dock

Working Environment

This product was designed to fulfil the EMC (Electromagnetic Compatibility)
requirements to be observed for so-called "Residential, commercial and
light industry environments". Dynabook do not approve the use of this
product in working environments other than the above mentioned
"Residential, commercial and light industry environments".
For example, the following environments are not approved:
Industrial Environments (e.g. environments where a mains voltage of
■
380 V three-phase is used)
Medical Environments
■
Automotive Environments
■
Aircraft Environments
■
Any consequences resulting from the use of this product in working
environments that are not approved are not the responsibility of Dynabook.
The consequences of the use of this product in non-approved working
environments may be:
Interference with other devices or machines in the near surrounding
■
area.
Malfunction of, or data loss from, this product caused by disturbances
■
generated by other devices or machines in the near surrounding area.
Therefore Dynabook strongly recommend that the electromagnetic
compatibility of this product should be suitably tested in all non-approved
working environments before use. In the case of automobiles or aircraft, the
manufacturer or airline respectively should be asked for permission before
use of this product.
Furthermore, for general safety reasons, the use of this product in
environments with explosive atmospheres is not permitted.

Canadian Notice

This device complies with Innovation, Science and Economic Development
Canada (ISED) (formerly Industry Canada) license-exempt RSS
standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage,
et (2) l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement.
EN-8 User's Manual