Regulatory Statements - Dynabook PA5356E-1PRP Manual Del Usuario

dynabook USB-C™ Dock
Never place your product or AC adaptor on a heat sensitive surface
Never place your product or AC adaptor on a wooden surface, furniture,
■
or any other surface that could be marred by exposure to heat since the
product base and AC adaptor's surface increase in temperature during
normal use.
Always place your product or AC adaptor on a flat and hard surface that
■
is resistant to heat damage.
CAUTION
Never expose your product to excess heat, extremely low
temperatures or sudden temperature variations
Never expose your product to excess heat, extremely low
■
temperatures, or sudden temperature variations. This may result in a
system failure, malfunction, loss of data or damage to your product.
Never operate your product during a thunderstorm
Never operate your product on AC power during a thunderstorm. If you
■
see lightning or hear thunder, immediately turn off the product. An
electric surge caused by the storm, may result in a system failure, loss
of data or hardware damage.

Regulatory Statements

Federal Communications Commission (FCC) Notice (USA)
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna(s).
■
Increase the separation between the equipment and receiver.
■
Connect the equipment into an outlet on a circuit different from that to
■
which the receiver is connected.
EN-6 User's Manual