Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4BAR USB QRG
Product
Description
Product
Overview
Footswitch
Overview
AC Power
Power Linking
Fuse
Replacement
The 4BAR USB is a pack-and-go must have for DJs, bands and other performers who
want a complete LED wash light system, featuring wireless DMX control with the
convenient built in D-Fi USB port. Each pod on the 4BAR USB has 108 high power
red, green, and blue LEDs, and can be positioned independently.
M icrophone
Fuse Holder
Pow er In
DIP
Sw itch
WARNING! DO NOT plug anything other than a D-Fi USB into the USB port.
Doing so may cause damage to the product.
This product has an auto-ranging power supply that can work with an input voltage
range of 100 to 240 VAC, 50/60 Hz.
To eliminate wear and improve its lifespan, during periods of non-use completely
disconnect from power via breaker or by unplugging it.
For the maximum number of 4BAR USB products that you can power link at each
voltage, see the User Manual or the sticker on the product.
To replace the fuse in the 4BAR USB:
1.
Disconnect the product from power.
2.
Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3.
Pry the safety cap out of the housing.
4.
Remove the blown fuse from the clip on the front of the safety cap and replace
with a fuse of the exact same type and rating.
5.
Re-insert the fuse holder and reconnect power.
LED Display
M enu
Buttons
Back Panel View
Pow er
Sw itch
3
DM X
In/ Out
D-Fi USB Port
9-Volt Battery
Cover
EN
Publicidad
Tabla de contenido
