Levelling The Washing Machine; Connecting The Water Supply Hose - Qilive Q.6855 Manual Del Usuario

3.2. UNPACKING THE WASHING MACHINE
Warning!
■ Packaging material (e.g. film, polystyrene foam) can be
dangerous for children.
■ Risk of suffocation! Keep all packaging materials out of the
reach of children.
1. Remove the cardboard box and polystyrene foam.
2. Lift the washing machine and remove the base packing.
Make sure the small triangle foam is removed with the
bottom piece together. If not, lay the unit down on its side,
and then remove the small piece of foam from the bottom
of the unit.
3. Remove the tape securing the power supply cord and drain
hose.
4. Remove the inlet hose from the drum.
3.2.1. REMOVE THE TRANSPORT BOLTS
Warning!
■ You must remove the transport bolts from the backside
before using the product
Follow the steps below to remove the bolts:
1. Loosen the 4 transport bolts with a spanner.
2. Remove the bolts including the rubber parts and keep them
for future use.
3. Close the holes using the cover caps..

3.3. LEVELLING THE WASHING MACHINE

Warning!
■ The lock nuts on all four feet must be screwed tightly against the housing.
3.4. CONNECTING THE WASHING MACHINE

3.4.1. CONNECTING THE WATER SUPPLY HOSE

Warning!
■ To prevent leakage or water damage, follow the instructions in this chapter!
■ Do not kink, crush or modify water inlet hose.
■ Connect manually, do not use tools. Check if the connections are tight.
1. Check if the legs are securely attached to the
housing. If not, turn them to their original positions
and tighten the nuts.
2. Loosen the lock nut and turn the foot until it is in
close contact with the floor.
3. Adjust the legs and lock them with a spanner,
making sure that the machine is steady.
11
EN