Connect the water supply hose to the water inlet valve and a water tap with cold water
EN
as indicated.
3.4.2. DRAIN HOSE
Warning!
■
Do not bend or stretch the drain hose.
■
Position the drain hose properly, otherwise damage may be caused due to water
leakage.
There are two ways to position the end of the drain hose:
1.
Put it into the water trough
Water
trough
4. USE
4.1. QUICK START
Caution!
■
Before washing, please make sure the washing machine is installed properly.
■
Your appliance was thoroughly checked before it left the factory. To remove any
residual water and to neutralize potential odors, it's recommended to clean your
appliance before first use. For this reason, start the Cotton program at 90°C
without laundry and detergent.
Calibration
It's recommended to calibrate the washing machine, so that provide the best
performance.
The appliance is able to detect the amount of laundry loaded. This function is
optimizing the product performance by minimizing energy and water consumption,
saving you money and time. For this reason it's recommended to calibrate the
appliance for best use.
1.
Remove all accessories from the drum and close the door
2.
Insert the mains plug to the socket;
3.
Switch on the washing machine and press "Delay" and "Spin"
simultaneously for 10 seconds until "t19" is displayed;
4.
Press [
] to start the appliance and wait till "****" is displayed
2.
Connect it to the branch drain pipe of
the trough..
12