Chacon 34036 Manual De Uso página 48

3. Alarm activation mode
Two methods of synchronisation:
a) Associating the detector with a central unit with
code: You just have to make the pre-registered
code to activate or deactivate the alarm. (see
corresponding manual)
b) Associating the detector with a classic control
panel + remote control: activate and deactivate
the alarm using the «on» and «off» buttons on
the remote control (see corresponding manual)
NOTE: This detector is compatible with the entire
range. You can therefore combine it with any device
while ensuring that you have at least one central
alarm unit (motion detector with or without code,
opening detector with code)
4. Reset pairing
In order to reset your entire alarm, remove the
batteries from your device. Then press and hold
the learning button of your central unit. When you
reinsert the batteries, you will hear two «beeps»
indicating that the reset was successful.
EN