Using For The First Time; Setting Up The Kettle - GUTFELS WATER 3300 C Manual De Instrucciones

8 Using for the first time

Checking the kettle and scope
of delivery
If you open the packaging carelessly
with a sharp knife or other pointed
objects, the kettle may be damaged.
• Remove the kettle from the
packaging.
• Check if the delivery is complete.
• Check the kettle and all the
individual parts for damage.
If this is the case, do not use the kettle.
Contact the service address provided.

Setting up the kettle

• Remove all protective films.
• Unwind the mains power cable
from the cable winder.
• Guide the cable through the recess
for the mains power cable.
• Place the base on a flat and stable
surface.
• Place the water container on the
base.
• Insert the mains plug into a socket
with protective contacts.
Operation
WARNING
DANGER OF SCALDING
AND BURNS!
The kettle gets hot during operation and
hot steam escapes, so you may get
burned or scalded!
If the cover is not closed properly when
the kettle is turned on, the kettle cannot
turn off automatically and the hot water
may boil over.
• Never touch the hot parts of the
kettle.
• Only pick up the kettle using the
handle. Also point out the dangers
to other users!
• Keep away from escaping water
vapour.
• Note that hot steam may escape
from the kettle even after it has
been switched off!
• Always close the cover before
turning on the kettle. Make sure
that the cover audibly engages
and is locked.
• Always keep the cover closed
when pouring out the heated
water.
WARNING
Risk of injury and damage!
If you heat too much water in the kettle,
hot water may spurt out of the water
container. If you heat too little water,
the kettle may overheat and be
damaged.
• When filling the water, note that
the water level must be between
MIN and MAX on the level
indicator.
• Press the cover lock button to
open the cover.
• Fill the desired amount of cold
water into the water container.
• Place the water container on the
base.
• Close the cover. Make sure that
the cover audibly engages.
• Press the on/off switch down. The
on/off switch and level indicator
light up and the water heats up.
When the water boils, the kettle
automatically turns off and the
light goes out.
• To interrupt the boiling process
prematurely, press the on/off
switch upwards.
• Wait a moment until the water
stops bubbling.
• Remove the water container from
the base.
• Pour out the water slowly through
the pouring opening.
The manufacturer recommends not to
reheat stagnant water. Pour it away or
use it cooled for watering flowers.
Dry run protection
To prevent damage to the kettle, the dry
run protection automatically switches on
when there is no liquid left in the kettle.
This function serves exclusively as a
safety device and is not intended to
increase operating comfort.
If the dry run protection has been
triggered:
• Remove the mains plug from the
plug socket.
• Allow the kettle to cool down.
EN
Page | 15