EINHELL PRESSITO Bivolt Manual De Instrucciones Original página 35

Protection from environmental infl uences
1. Wear suitable work clothes. Wear safety gog-
gles.
2. Protect your cordless tool and the battery
charger from moisture and rain. Moisture
and rain can cause dangerous cell damage.
3. Do not use the cordless tool or the battery
charger near vapors and infl ammable liquids.
4. Use the battery charger and cordless tools
only in dry conditions and an ambient tempe-
rature of 10-40°C.
5. Do not keep the battery charger in places
where the temperature is liable to reach over
40°C. In particular, do not leave the battery
charger in a car that is parked in the sunshine.
6. Protect batteries from overheating. Over-
loads, over-charging and exposure to direct
sunlight will result in overheating and cell
damage. Never charge or work with batteries
which have been overheated – replace them
immediately if possible.
7. Storage of batteries, battery chargers
and cordless tools. Store the charger and
your cordless tool only in dry places with an
ambient temperature of 10-40°C. Store your
lithium-ion battery pack in a cool, dry place at
a temperature of 10-20°C. Protect them from
humidity and direct sunlight. Only place fully
charged batteries in storage (charged at least
40%).
8. Prevent the lithium-ion battery pack from free-
zing. Battery packs which were stored below
0°C for more than 60 minutes must be dispo-
sed of.
9. When handling batteries beware of electro-
static charge: Electrostatic discharges cause
damage of the electronic protection system
and the battery cells. Avoid electrostatic char-
ging and never touch the battery poles.
Rechargeable batteries and cordless electric
machines and tools contain materials that are po-
tentially harmful to the environment.
Anl_SA_PRESSITO_Bivolt_SPK8.indb 35 Anl_SA_PRESSITO_Bivolt_SPK8.indb 35
GB
Never place any cordless electric machines or
tools in your household refuse. When cordless
electric machines or tools become defective or
worn, remove the rechargeable batteries accor-
ding to your local environment protection laws.
Safety information for the compressor
Danger! The following basic safety actions
must be taken when using this compressor
in order to protect the user from electric
shocks and the risk of injury and fi re. Read
and follow these instructions before using
the equipment.
•
Check the ambient conditions
Do not expose the compressor to rain. Never
use the compressor in damp or wet locations.
There is a risk of electric shock! Provide good
lighting. Do not use the compressor near
flammable liquids or gases. There is a risk of
explosion!
•
Protect yourself against electric shocks
Avoid bodily contact with earthed parts, e.g.
pipes, radiators, cookers and refrigerators.
•
Keep children away!
Do not allow other persons to touch the com-
pressor or cable, keep them away from your
work area.
•
Do not use the cable for purposes other
than that for which it is designed
Do not carry the compressor by its cable and
do not use the cable to pull the plug out of the
socket. Protect the cable from heat, oil and
sharp edges. The cable/plug could become
damaged.
•
Take care of your compressor
Keep your compressor clean in order to work
well and safely. Follow the maintenance inst-
ructions. Check the power plug and cable on
a regular basis and have them replaced by
an authorized specialist if they are damaged.
Check the extension cable regularly and re-
place it if damaged.
•
Avoid unintentional starting
Make sure that the switch is turned off when
connecting to the power supply.
•
Check your compressor for damage
Before using the compressor again, carefully
check the safety devices and any slightly da-
maged parts to ensure that they are in good
working order. Check that the moving parts
are working correctly, that they do not jam,
and that no parts are damaged. Make sure
that all parts are fitted correctly to ensure that
the equipment remains safe to use. Unless
otherwise stated in the operating instruc-
- 35 -
15.10.2018 10:59:20 15.10.2018 10:59:20