Radio Operation; Cassette Operation - Denver MCA-54 Instrucciones De Uso

All manuals and user guides at all-guides.com
OPERATING THE UNIT
g
When the unit is plugged into the mains, it is automatically switched to standby mode. To switch it on and off,
simply press the POWER button on the unit or the remote control. If you want to switch the power off
completely, you must unplug the power cord from the AC outlet.
POWER / STANDBY
g
1. Press the POWER button on the unit (or the remote control) to switch it on.
2. Select the audio source (CD, Radio or Tape) by setting the function selector to the corresponding position.
3. Adjust the volume using the VOLUME button.
4. Press the POWER button the switch off the unit.
LISTENING TO MUSIC WITH HEADPHONES
g
The unit is equipped with a jack for headphones. Insert the plug at the end of the headphone lead in this
jack. It is recommended to start listening at a low volume and increase the volume slowly until the desired
level is obtained.
BBS SYSTEM
g
Pressing the BBS button boosts the bass level during playback.
MUTE FUNCTION (on remote control)
g
Pressing the MUTE button on the remote control switches off the audio output temporarily. Press this button
again to resume normal playback.

RADIO OPERATION

g
Set the function selector to RADIO.
FM
Select FM or FM STEREO using the BAND SELECTOR. Turn the TUNING KNOB until you have found the
desired station. The FM STEREO indicator light comes on when a stereo broadcast is received. Extend the
FM antenna completely and orient it to obtain the best possible FM reception.
AM
Select AM using the BAND SELECTOR. Turn the TUNING KNOB until you have found the desired station.
For AM reception, the unit is equipped with a built-in ferrite frame antenna which is directional. Therefore,
the unit must be oriented in order to pick up the strongest possible signal.

CASSETTE OPERATION

g
Set the function selector to TAPE.
Playing a cassette
Ensure that the tape is taut in the cassette before use. To correct any slack in the tape, use a hexagonal
pencil or pen: insert it in the centre of the spool and turn it in order to tighten the tape. Press the CASS.
STOP / EJECT button to open the cassette door.
Insert a cassette into the compartment, with the open end facing downwards and the full reel on the left.
Insert the cassette firmly into the compartment and close the door, taking care not to touch the tape surface.
For playback, press the PLAY button. To interrupt playback briefly, press the PAUSE button on the unit. To
resume playback, press the PAUSE button again. To stop playback, press the STOP / EJECT button once.
To remove the cassette from the compartment, press the STOP / EJECT button again.
GB-5