KNOVA KN M-3059R Manual Del Usuario página 16

ADJUSTMENT
CUTTING HEAD DOWNWARD TRAVEL ADJUSTMENT
(FIG. Y)
Before each cutting operation, check the position of the blade
to make sure it does not contact any metal surface. If it
contacts any metal surface, the depth of movement must be
adjusted.
WARNING
To avoid injury from unexpected starting or
electrical shock, make sure the trigger switch is
disengaged and remove the power cord from the power
source.
1. Lower the blade as far as possible.
2. Loosen lock nut (1) using an adjustable wrench.
3. Turn the adjustment bolt (2) out (counterclockwise) to
decrease the cutting depth or in (clockwise) to increase
the cutting depth.
4. Rotate the blade by hand to check that it does not contact
any metal.
5. Repeat steps until adjusted properly, and tighten the lock
nut (1) to secure the adjustment bolt (2) into position.
2
1
TURNING LASER GUIDE ON (FIG. Z)
1. To turn laser on, press on/off rocker switch (1) to "ON"
position.
2. To turn laser off, press on/off rocker switch to "OFF"
position.
Fig. Z
ALIGNING THE LASER GUIDE
The laser line must always be correctly aligned with the blade
to ensure straight, even cutting. Your tool is equipped with
the Laser guide cutting guide using Class IIIa laser line. The
laser line will enable you to preview the saw blade path on
the stock to be cut before starting the miter saw. This laser
guide is powered by the transformed alternating current
supply directly through the power lead. The saw must be
connected to the power source and the laser on/off switch
must be turned on for the laser line to show.
WARNING
padlock (not provided) through the hole in the ON/OFF
Trigger Switch prior to making any laser adjustment.
• Do not remove the lock from the ON/OFF Trigger Switch
during any laser adjustment.
AVOID DIRECT EYE CONTACT WITH LASER (FIG. Z, AA)
WARNING
aperture when the laser guide is turned on. Avoid
direct eye contact. (Fig. Z)
• Laser Warning Label:
Max. Output < 5 mW Wavelength: 630-660nm, Complies
with 21 CFR 1040.10 and 1040.11. Class IIIa Laser
Product. (Fig. AA)
Fig. Y
• Laser Aperture Label: AVOID EXPOSURE: Laser
radiation is emitted from this aperture. (Fig. AA)
• NOTE: All the adjustments for the operation of this
1
machine have been completed at the factory. Due to
normal wear and use, some occasional readjustments
may be necessary.
• CAUTION: Use of controls or adjustments or performance
of procedures other than those specified herein may
result in hazardous radiation exposure.
• CAUTION: The use of optical instruments with this
product will increase eye hazard.
• WARNING: Do not attempt to repair or disassemble the
laser. If unqualified persons attempt to repair this laser
product, serious injury may result. Any repair required on
this laser product should be performed by a qualified
service dealer.
15
• To prevent serious injury, insert a
• A laser line radiates from the laser