Adjustments - KNOVA KN M-3059R Manual Del Usuario

ASSEMBLY
ADJUSTMENT
REMOVING AND INSTALLING THE BLADE
WARNING
• Only use 12 inch diameter crosscut
blades on this saw. Do not use blades with deep
gullets. These can deflect and contact the guard, and
can cause damage to the machine and/or serious
injury. To avoid injury from an accidental start, make
sure the switch is in the OFF position and the plug is
not connected to the power source outlet.
NOTE: The miter saw comes with the saw
blade already installed.
• Make sure the blade is installed correctly and is tight
before operating.
Removing the Blade (Fig. O, P, Q)
1. Unplug the saw from the outlet.
2. Raise the cutting head to the upright position.
3. Raise the lower blade guard (1) to the uppermost position.
(Fig. O)
4. Loosen the cover plate screw (2) with a Phillips screwdriver.
5. Rotate the cover plate (3) back to expose the arbor bolt (4).
6. Place the provided blade wrench over the arbor bolt (4).
7. Locate the arbor lock button (5) below the trigger switch
handle. (Fig. P)
8. Press the arbor lock button (5), holding it in firmly while
turning the blade wrench clockwise. This will engage the
arbor lock allowing the arbor bolt to be loosened with the
blade wrench. Continue to hold the arbor lock button (5)
while turning the wrench clockwise to loosen the arbor bolt.
9. Remove the arbor bolt (4), the outer blade collar (6), and
the blade (7). (Fig. Q)
Carrying handle
CAUTION
Do not remove the inner blade collar (8).
NOTE: Pay attention
to the pieces
removed, noting
their position
and direction
they face.
Wipe the blade
collars clean of
any sawdust
before installing
a new blade.
Fig. N
5
6
4
Installing the Blade (Fig. O, P, Q)
WARNING
installing the blade.
1. Install a 12 in. blade with a 1 in. arbor hole, making sure the
rotation arrow on the blade matches the clockwise rotation
arrow on the upper guard, and the blade teeth are pointing
downward at the front of the saw.
12
1
Fig. O
Do not
7
remove
8
Un-plug the miter saw before changing/
2
3
4
Fig. P
9
Fig. Q