KERN MSF 200N Instrucciones De Servicio página 15

6 Unpacking/installing
Testing upon Please check packaging as well as the device on receipt for
acceptance possibly visible external damages.
Packaging/ Keep all parts of the original packaging for a possibly required
Return return.
Only use original packaging for returning.
Checking the After the assembly of the height measuring rod, the scale must
scale be checked using an external measuring rod.
For this put an external, verified measuring rod with the re-
spective accurateness on the weighing plate or, in case of wall
assembly, vertically on the floor. The height measuring rod
must be shifted in a way that the horizontally unfolded flap
touches the external measuring rod with the lower side at 150
cm.
Information:
The measure of the external measuring rod is not congruent
with the scale of the height measuring rod, it is displaced by
some cm, as the offset between the flap and the reading mark
thus will be considered.
If the measure does not match exactly, loosen again slightly
and shift a little the screws used for assembly and then check
again the measure of 150 cm.
MSF-BA-EU-1715 15