Operation; Switching On/Off; On/Off Indicator; Switching Between The Computer And The Clearview+ Or Another Device - Optelec TwinView Manual Del Usuario

Optelec TwinView

4. Operation

The control buttons of the TwinView are located on the front panel of the unit, below the
screen.

4.1 Switching on/off

To power the TwinView, press the On/Off button located at the bottom right of the
monitor. When no signal is detected, the TwinView will switch off automatically.

4.2 On/Off indicator

When the TwinView is switched on, the indicator will be lit green. When no input signal is
detected, the indicator will be lit orange. When the unit is switched off, the indicator will not
be lit.
4.3 Switching between the computer and the ClearView+ or another
device
Press the button located at the left below the screen (labelled A) to display the full
ClearView+ image. To display the full PC image, press the button labelled B (to the right of
the cursor cross). When no input signal is detected, the TwinView will automatically switch
channels after 5 seconds.
Please note: to display the PC image correctly on your TwinView monitor, make sure that
the resolution of your PC is set to 1920x1080.

4.4 Activating the split screen functionality

Pressing the A/B button – the centre button of the cursor cross – enables the split screen,
displaying both the PC and the ClearView+ images simultaneously.

4.5 Switching between vertical and horizontal split screen

To switch between a vertical or horizontal split, press the left or right arrow for a vertical
split, or the up and down arrow for a horizontal split.
Page 13