Scott Safety FH3 Instrucciones De Funcionamiento Y Mantenimiento página 9

DOFFING
CAUTION Do not remove the headtop
until you are in a safe and hazard free
zone
Once free of any hazard switch off the
blower
Loosen the helmet handwheel
Pull the face seal away from under the
chin and off the face
Pivoting the mask away from the face, lift
the headtop off of the head
Place the headtop onto a clean surface
Remove the PAPR in accordance with the
Operating and Maintenance instructions
Proceed with after use cleaning and
storage
AFTER USE CARE
Note If during use the equipment may
have become contaminated by hazardous
substances, the contamination must be
identified and properly removed or the
contaminated components
replaced before next use.
Disposal of the contaminated components
must be carried out in accordance with
local regulatory requirements.
Disconnect the breathing hose from the
blower
Inspect the headtop for worn, ageing or
damaged components
Carefully wipe clean the headtop with a
warm water solution containing a mild
detergent
It is recommended that headtop visors be
wiped clean with Distel
If necessary, wash the outside of the
breathing hose carefully using warm water
solution containing a mild detergent
Ensure the breathing hose connections are
free from all dirt or debris that could prevent
an effective seal with the blower
Once clean all components must be left to
dry naturally.
must be
wipes
®
STORAGE
Device must be protected from damage
during transportation.
When not in use the equipment should be
stored in a clean, dry environment, away
from direct heat sources between -10ºC
and +50ºC, at a humidity of less than 75%
RH.
SPARES
Replacement parts
may be ordered through Scott Safety
customer services. The department can
also provide general information on other
Scott Safety products.
Scott Safety
Pimbo Road, West Pimbo,
Skelmersdale, Lancashire,
WN8 9RA, England
www.scottsafety.com
scott.sales.uk@tycoint.com
Tel: +44 (0) 1695 711711
Fax: +44 (0) 1695 711775
WARRANTY
The products
factories in Skelmersdale and Vaasa carry
a warranty of 12 months (unless stated
otherwise). This includes parts, labour
and return to site The warranty period
runs from the date of purchase by the end
user.
These products are warranted to be free
from defects in materials and workmanship
at the time of delivery. Scott Safety will
be under no liability for any defect arising
from wilful damage, negligence, abnormal
working conditions, failure to follow the
original manufacturer's
misuse or unauthorised alteration or
repair.
Evidence of purchase date will need to
be produced for any claims arising during
the warranty period. All warranty claims
must be directed through Scott Safety
customer services and in accordance with
our sales return procedure.
7
and accessories
manufactured at
instructions,
our
FH3