Chain Oil - EDM Koma Pro 08337 Manual De Instrucciones

Refueling of the machine:
1. Choose a suitable area to perform this operation.
2. Shake the container that has the already prepared
mixture of gasoline and oil.
3. Remove the fuel tank cap and fill with the gasoline
and oil mixture.
4. Tightly close the cap of the fuel tank and remove
all fuel which may have spilled on the outside with
a dry cloth.
WARNING:
Stop the motor before refueling.
Do not ever perform this operation in a
closed or unventilated area.
Separate yourself at least 3 metres from the refueling
area before starting the machine.
Do not remove the cap of the fuel tank while the engine
is running.

6.3.3 CHAIN OIL

Use only special chainsaw oil. Do not use other oil
that is not for chainsaw chains since it will damage the
machine oil pump.
Insert the chain oil in the chain oil tank. This oil tank
can be recognized by the corresponding icon (indicated
in Chapter 5 "Symbols on the machine").
6.4. START UP
Remove the protector (1).
1
Before starting the machine, make sure that the moving
parts of the machine are not in contact with any object.
6.4.1. COLD-STARTING THE ENGINE
1. Set the switch in the start position
"I".
2. Press the "primer" choke several times (from 7 to
10) to ensure that the fuel has reached the
carburetor.
3. Pull the air lever CHOKE
4. Place the machine on the floor in a
stable and
horizontal position.
5. Firmly hold the front handle with your left hand and
hold the rear of the saw with your right knee.
6. Pull the starter cord until the motor starts or makes
an explosion.
7. Push in the air level (normal
working position RUN).
8. If the tool has not started, pull the starting rope
again (6) until it starts.
9. Leave the engine to warm up for a few minutes
before using the machine
79/130
English
I
0
..