Using The Machine - EDM Koma Pro 08337 Manual De Instrucciones

6.5.2. CHECK OF THE AUTOMATIC CHAIN
You can adjust the oil flow with
the adjusting screw (1) oil that
is below the chainsaw next to
the clutch.
To regulate oil flow turn the screw clockwise "MAX"
If you want to increase it, or turn the screw 'MIN' to
decrease it. The indications "MAX" and "MIN" are at
the bottom of the machine. Be sure to fill the chain oil
tank whenever refilling fuel.
6.5.3. CHECK OF PROTECTION AGAINST BOUNCING
Bouncing of the machine is the greatest risk
of this machine.
This machine has an automatic brake to stop the
rotation of the chain where a rebound occurs during
use.
6.5.4. CHECK OF THE SECURITY BRAKE
Accelerate the chainsaw to its maximum revs and push
the safety brake lever forward. The chain should stop
immediately with the engine at full power.
If the chain not is for or takes to stop take the machine
for service. Check the emergency brake whenever you
start using the machine.
LUBRICATION
After starting the engine,
speed up the chainsaw until
the chain turns at an average
speed and check if the chains
saw greases the chain, this
will be easily seen when you
place the chainsaw as in the
figure, oil will come out.

7. USING THE MACHINE

Use this machine only for the designated purposes.
Using this chainsaw for any other use is dangerous and
can cause bodily harm and/or damage to the machine.
Do not approach the chain when the motor is
running.
Do not trust only in the security measures of this
machine.
Do not use this machine if you are fatigued,
ill, or are under the influence of medication,
drugs, or alcohol.
Fatigue and the lack of rest can cause accidents or
damage. Limit continued use of this machine to 10
minute time intervals and rest for 10-20 minutes to rest
between each session.
Always hold the chainsaw with the two
hands and keep subject handles while the
engine is on unless you are performing a
pruning height with rope and harness. If
you firmly hold the machine by the handles will reduce
the risk of rebound and will increase its control over
the machine.
Remember to always use the machine with clean hands
and without any fuel or oil.
Pay special attention if you use this machine in the rain
or after raining, as the soil will be slippery and you
may slip.
If you slip or fall, stop accelerating and move the
switch to the position "O" (shutdown).
Clean the work area and remove all obstacles that may
81/130
English