Usage - Silvercrest SIKP 2000 F1 Manual De Instrucciones E Indicaciones De Seguridad


Do not place the device on metal surfaces. These can heat up quickly and cause a fire.

Never place the device under flammable items such as curtains.

The openings on the bottom of the product must never be covered. Keep a distance of at
least 10 cm clear all around the device and at least 60 cm clear above it to guarantee
sufficient cooling.

7.2 Usage


If you switch the induction hotplate off and the surface temperature of the heating zone
(2) is higher than 60 °C, "– H –" is shown on the display. If the temperature drops
below 60 °C, the display shows "– L –".

If you remove the pan from the induction hotplate when in use, the display shows "E0"
and a beeper sounds every 2 seconds. After around 60 seconds, the beeper stops and
the fan switches off. The display (11) continues to show "– H –" for as long as the
surface temperature of the heating zone (2) is greater than 60 °C. If the temperature
drops below 60 °C, the display (11) shows "– L –".

The only way to hide the "– H –" and "– L –" symbols from the display (11) is by
disconnecting the product from the mains.

When the induction hotplate is switched on, the preset power level is L05.
1. Connect the induction hotplate to a live mains socket using the power cable (1). A beeper then
sounds and the display (11) shows "– L –" or "– H –" depending on the temperature.
2. Place a pan on the hotplate (2).
SilverCrest SIKP 2000 F1
English - 47