Section 5. Operating Instructions; Setting The Clock; Modes And Setting The "Timers - Polaris AutoClear SC PAGSC20K Manual De Operación Y Instalacion

Page 16
ENGLISH

Section 5. Operating Instructions

WARNING
To avoid property damage, serious injury or death,
do not operate the electrolytic cell without water
circulation. A buildup of flammable gasses which can
result in FIRE OR EXPLOSION.

5.1 Setting the Clock

The saltwater chlorine generator is fitted with an internal
memory and is fitted with battery back up that will
maintain memory for several weeks in the event of a
power failure. The time is displayed in a 24 hour format.
Switch on the device and wait until screen start-up
sequence is finished.
• Press the button to access the user menu, the
minutes start to flash.
Polaris
•
•
•
• Exit the User Menu 5.2 Setting the "Timers"
• Deactivate Boost
"Timer' programming is used to schedule the filter pump
Mode
run time. The daily operating times must be sufficient
to correctly treat the water. The saltwater chlorine
generator has default settings of Timers 1 and 2.
• From the Home
However they can be customized.
screen: Increase /
Decrease chlorine
NOTE: When connecting to a Polaris PAC Pool Automation
production
• In the User Menu:
When value flashes,
press Up / Down to
select from choices
The device operating times, the "timers": T1 (Timer 1)
and T2 (Timer 2)
• Press to switch
between User Menu
and Navigation
Menu
• Short press: Switch
on power; or after
power on, activate /
•
deactivate the Filter
Pump
•
• Long press: Switch
off power
Programming the Timers According to the Modes
The times of Timers 1 and 2 cannot overlap. In addition,
• Press both buttons
the time range of Timer 1 necessarily precedes that of
together: Activate
Timer 2.
Boost mode (sets
production to 100%
for 24 hours).
Returns to previous
set point after the 24
period ends
•
•
AutoClear SC Salt Chlorinator
® TM
Use the and buttons to set the minutes, then
press to store and advance to the hours setting.
Use the and buttons to set the hours,
then press to store to store and advance to
chlorine production setting.
Press the button to return to the home screen.
Control timers should be left in the default 24 hour run
time to allow the Automation to control the run time.
T1
STANDBY = Device operating status
T = "Timer" mode (always active)
80 % = chlorine production rate
14:25 = time in 24 hr format
Press 4 times to set the clock.
Use the and buttons to choose time for
Timer 1.
T1
T2
T1 / T2 = Timer mode No. 1 / Timer mode No. 2
08:00-12:00 = Operating time range of Timer No. 1
14:00-20:00 = Operating time range of Timer No. 2
Use the and buttons to set the Timer
1 stop minutes, then press
Use the and buttons to set the Timer
1 stop hours, then press
|
Installation and Operation Manual
to store.
to store.