Replace The Impeller - GreenWorks 2600802 Manual Del Operador

EN
1. Remove the screws(1) that are located beneath the
impeller.
2. Remove and discard the old scraper.
3. Install the new scraper.
4. Put in the screws and spacer(2) and then tighten them.
8.3

REPLACE THE IMPELLER

1. Remove 6 screws on the right side cover.
2. Pull the belt tensioner away from the engine pulley. Make
sure that the washer, spring and screw are not missing.
3. Remove the belt.
4. Remove the 4 screws.
5. Remove the 6 screws on the left side cover.
English
6. Remove the nut on the left side plate.
7. Remove the impeller shaft with pulley assembly attached.
8. Remove the damaged impeller (13). Make sure that the
shaft sleeve on the left side of the shaft is not missing.
9. Install the impeller shaft with pulley assembly attached in
the new impeller. Make sure that you replace the retained
shaft sleeve on the left side of the shaft.
10