Unpack The Machine; Connect The Shafts; Install The Upper Handle; Operation - GreenWorks 2600802 Manual Del Operador

EN
6.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
6.2

CONNECT THE SHAFTS

2
3
1. Align the pin(1) on the handle shaft(2) and the hole(1) on
the lower shaft(4).
2. Turn the lock knob(5) clockwise until it is fully tightened.
WARNING
WARNING
4
5
1
English
6.3

INSTALL THE UPPER HANDLE

1. Push the auxiliary handle (1) onto the upper shaft so that
the handle is angled toward the rear handle that allows for
comfortable operation.
2. Move the auxiliary handle over the metal ring (2) and
ensure the metal ring fits between the slot on the auxiliary
handle.
3. Align the holes on the auxiliary handle with the holes on
metal ring.
4. Insert the handle knob (3) through the auxiliary handle.
5. Tighten until there is no movement in the handle.
7

OPERATION

Wear eye protection during operation.
7.1

START THE MACHINE

1
2
1. Verify that the machnie is plugged in.
2. Press and hold the lock-out button(1).
3. While holding the lock-out button(1), press and hold the
trigger switch(2). Once the unit has started, you can
release the lock-out button(1) .
Keep bystanders a safe distance from the machine.
8
1
2
3
WARNING
WARNING