Setup - Dell UltraScan P990 Guia Del Usuario

DELL P990(E).book Page 3 Friday, December 4, 1998 2:36 PM

Setup

Setup
1. Make sure the computer system and monitor are switched off and attach
the Blue video signal cable to the Blue video output of the computer.
Both are a Blue color
2. Make sure the monitor is switched off and attach the power cord to the
monitor. Then, attach the other end of the power cord to a power outlet.
3. Switch on the monitor and computer.
4. Adjust the user controls according to your personal preference.
Installation is complete.
NOTE: If you have any problems with your Dell Monitor, refer to the "Troubleshooting"
section on pages 1-15 to 1-19.
All manuals and user guides at all-guides.com
Computer
Power cord
to an AC power outlet
Video
Signal cable
to the video output
connector on the computer
Video Signal Cable
Setup 1-3