SNOWJOE SJ627E-CVR Manual Del Operador página 8

Fig. 9
NOTE: Do not overtighten the knob.
Chute Crank Assembly
1. Remove the hitch pin from the female end of the lower
chute crank (Fig. 10).
Fig. 10
Lower chute crank
(female end)
2. Install the lower crank rod by inserting it into the opening
at the back of the housing and aligning the holes (Fig. 11).
Fig. 11
Align the
holes
Hitch Pin
Lower chute crank
3. Secure the lower chute crank in place with the hitch pin
(Fig. 12).
Fig. 12
4. Remove the other hitch pin from the lower chute crank
(Fig. 13).
Fig. 13
Lower chute
crank
5. Slide the upper chute crank through the rubber ring
located on the middle frame (Fig. 14).
Fig. 14
Rubber ring
8
Hitch pin
Hitch Pin
Upper chute crank