Identification Of Parts; Positioning The Unit; Operating The Unit; When Using The Unit - INVENTOR PR1-ION30XL Manual Del Usuario

IDENTIFIC ATION OF PA RTS
I dentification of parts
Front
Control panel
1
2 Handle (both sides)
Air outlet grille
3
Water bucket
4
Rear
1 Drain hose outlet
2 Caster
3
Power Cord and plug
Power Cord buckle
4
Air intake grille
5
6 Air filter (behind the grill)
Shoes dryer cover
7
Shoes dryer pipe
8
N O TE: All the pictures in the manual are
for explanation purposes only. The actual
shape of the unit you purchased may be
slightly different, but the operations and
functions are the same.
All manuals and user guides at all-guides.com
1
3
2
4
Fig.2
7
6
8
5
1
4
2
3
Fig.3

Positioning the unit

A dehumidifier operating in a basement will have little or no effect in drying an adjacent enclosed
storage area, such as a closet, unless there is adequate circulation of air in and out of the area.
Do not use outdoors.
This dehumidifer is intended for indoor residential
applications only. This dehumidifier should not be used
for commercial or industrial applications.
Place the dehumidifier on a smooth, level floor strong
enough to support the unit with a full bucket of water.
Allow at least 20cm of air space on all sides of the unit
for good air circulation.
Place the unit in an area where the temperature will not
fall below 5 C(41 F). The coils can become covered with
frost at temperatures below 5 C(41 F), which may reduce
performance.
Place the unit away from the clothes dryer, heater or radiator.
Use the unit to prevent moisture damage anywhere books
or valuables are stored.
Use the dehumidifier in a basement to help prevent
moisture damage.
The dehumidifier must be operated in an enclosed
area to be most effective.
Close all doors, windows and other outside openings
to the room.
W hen using the unit
When first using the dehumidifier, operate the unit
continuously 24 hours.
This unit is designed to operate with a working
environment between 5 C/41 F and 35 C/95 F.
O O O O
If the unit has been switched off and needs to be
switched on again quickly, allow approximately
three minutes for the correct operation to resume.
Do not connect the dehumidifier to a multiple socket
outlet, which is also being used for other electrical
appliances.
Select a suitable location, making sure you have easy
access to an electrical outlet.
Plug the unit into a electrical socket-outlet with earth
connection.
Make sure the Water bucket is correctly fitted otherwise
the unit will not operate properly.
NOTE:
When the water in the bucket reaches to a certain
level,please be careful to move the machine to avoid it
falling down.
OPE R ATI NG TH E UNIT
40cm or
more
Air outlet grille
Air intake
grille
20cm or more
20cm or more
20cm or more
20cm or more
Fig.4a
Casters(At four points on the bottom of unit)
Casters can move freely.
Do not force casters to move over carpet,
nor move the unit with water in the bucket.
(The unit may tip over and spill water.)