General Specifications - Klein Tools ET450 Manual De Instrucciones

ENGLISH
The Klein Tools ET450 Advanced Circuit Tracer kit is a professional tracer for
energized and de-energized breakers, fuses, and wires. When the Transmitter
is connected to a circuit, the Receiver's sensitivity can easily be adjusted to
detect the transmitted signal on breakers, fuses, and wire through drywall,
cement block, and underground.
• Environment: Indoor. DO NOT expose to moisture, rain, or snow.
• Operating Altitude: 6562 ft. (2000 m)
• Relative Humidity: <85% non-condensing
• Operating Temp: 32° to 122°F (0° to 50°C)
• Storage Temp: -4° to 140°F (-20° to 60°C)
• Calibration: Accurate for one year
• Standards: IEC EN 61010-1, 61010-2-030.
Conforms to UL STD.61010-1, 61010-2-030;
Certified to CSA STD.C22.2 No.61010-1, 61010-2-030.
5001748
• Pollution degree: 2
• Drop Protection: 6.6 ft. (2m)
• Safety Rating: ET450T: CATIII 600V
CAT III: Measurement category III is applicable to test and measuring
circuits connected to the distribution part of the building's low-voltage
MAINS installation.
CAT II: Measurement Category II is applicable to test and measuring
circuits connected directly to utilization points (socket outlets and similar
points) of the low-voltage MAINS installation.
• Electromagnetic Environment: IEC EN 61326-1. This equipment
meets requirements for use in basic and controlled electromagnetic
environments like residential properties, business premises, and light-
industrial locations.
Specifications subject to change.
To ensure safe operation and service of the meter, follow these instructions.
Failure to observe these warnings can result in severe injury or death.
• Risk of electric shock and burn. Contact with live circuits could result in death or
serious injury.
• NEVER use the tester on a circuit with voltages that exceed the category-based
rating of this tester.
• Inspect the meter and test leads before use. DO NOT use if they appear
damaged or malfunctioning in any way
• Ensure leads are fully seated, and use caution when connecting to live circuits
• DO NOT use testers during electrical storms or in wet weather.
• Turn off testers and disconnect test leads before attempting to replace batteries.
• Turn off testers and disconnect test leads before attempting to replace the fuse.
• To avoid electrical shock, do not operate the tester while battery door is
removed.
• DO NOT open the case, other than the battery compartment.
• Use caution when working with voltages above 25V AC RMS, or 60V DC. Such
voltages pose a shock hazard.
• ALWAYS adhere to local and national safety codes. Use personal protective
equipment to prevent shock and arc blast injury where hazardous live
connectors are exposed.
2

GENERAL SPECIFICATIONS

ET450R: CAT III 600V, CAT II 1000V, Class II, Double insulation
WARNINGS - GENERAL