VONROC VC507DC Traducción Del Manual Original página 7

The charger has 2 LED indicators (19) which
indicate the status of the charging process:
Red LED Status Green LED status
Off Off
Off On
On Off
• Fully charging the 2Ah battery may take up to
60 minutes.
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the
charger plug from the outlet and remove the
battery from the charger.
• Slide the HEPA filter (12) over the filter
holder(13) as shown in Fig. D.
Clean the HEPA filter (12) regularly and
after every heavy use to maintain the
suction power.
• Place the top section (8) on the container (7) as
shown in Fig. E-1.
• Secure the metal locking clamps (5) of the
container to the top section (8) as show in Fig.
E-2.
• Close the metal locking clamps (5) by pushing
them downwards.
• Connect the suction hose (9).
For vacuuming (Fig. F): Connect the suction
hose (9) to the vacuum port (3).
For blowing (Fig. G): Connect the suction hose
(9) to the blowing port (4).
• Connect the round nozzle (10) or the crevize
nozzle (11) to the hose (9).
4. OPERATION
Switching the machine on/off (Fig.A)
Do not vacuum without a Hepa filter!
WWW.VONROC.COM
• To switch on the vacuum cleaner, move the On/
Off switch (1) forwards (direction ON).
• To switch off the vacuum cleaner, move the On/
Charger status
Off switch (1) backwards (direction OFF).
No power
Vacuuming (Fig. D, E-1, E-2, F)
Standby mode:
- No battery is
inserted or,
- Battery inserted
but charging has
finished
Battery charging in
progress
1. Switch off (1) the machine and remove the
battery (14).
2. Unlock the metal locking clamps (5) and remove
the top section (8).
3. Before vacuuming, remove all dirt and debris
from the container (7).
4. Fit the filter. Carefully slide the HEPA filter (12)
over the filter holder (13) as shown in Fig. D.
5. Place the top section (8) on the container (7) as
shown in Fig. E-1.
6. Reattach the top section (8) again and lock the
locking clamps (5). Fig E-2.
7. Insert one end of the hose (9) into the
vacuuming port (3).
8. Place the battery (14).
9. Press the power switch (1) into the "
ON/1"position to start your ash cleaner.
10. The machine now is ready to use for vacuum
cleaning.
11. Press the power switch (1) into the "
OFF/0"position to switch off your ash cleaner.
Blow function (Fig. E-1, E-2, G)
Clean the HEPA filter (12) regularly and
after every heavy use to maintain the
suction power.
Fine dust, such as dust from cement, soot
and plaster are too fine to be used. Risk for
getting into the motor and damaging it.
Operation without the use of a filter is
recommended.
Remove all dirt and debris from the
container(7) before you use the blow
function.
Always wear safety goggles before using
the blowing function.
Risk of flying objects. Keep bystanders
away from the work area.
EN
7