VONROC VC507DC Traducción Del Manual Original página 8

EN
Your ash cleaner is equipped with a blowing
function. This function can be used to blow ash
remains and dust out of corners and crevices which
are difficult to access with vacuuming.
1. Switch off (1) the machine and remove the
battery (14).
2. Unlock the locking clamp (5) and remove the
top section (8).
3. Before blowing, remove the filter (12) and
remove all dirt and debris from the container
(7).
4. Reattach the top section (8) again and lock the
locking clamps (5). Fig. E-1, E-2.
5. Insert one end of the hose (9) into the blowing
port (4) on top of machine. Fig. G.
6. Place the battery (14).
7. Press the power switch (1) into the "
ON/1"position to start your ash cleaner.
8. The machine is now ready for blowing ashes
and dust.
9. Press the power switch (1) into the "
OFF/0"position to switch off your machine.
Finish operation (Fig. F)
1. Turn off (1) the machine and remove the battery
(14).
2. Remove the top section (8) and empty the
container (7).
3. Clean the machine with a soft cloth.
4. Disconnect hose, tube and container.
5. Clean hose connectors, hose and tube after
use, and keep them unblocked.
6. Stow away the hose and accessory at the
machine. Store the appliance in a dry room.
5. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
battery pack from the machine.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that
the ventilation openings are free of dust and
dirt. Remove very persistent dirt using a soft
cloth moistened with soapsuds. Do not use any
solvents such as gasoline, alcohol, ammonia, etc.
Chemicals such as these will damage the synthetic
components.
8
Filters (Fig. B)
For optimal performance it is recommended
to regularly change the filter (12)
depending on level of use.
1. Carefully remove HEPA filter (12).
2. Clean the dust on the HEPA filter (12) with a
brush, and if necessary, wash it.
3. Do not use cleaning products, solvents or sharp
objects for any cleaning of the appliance, this
includeds the washable HEPA filter
4. Allow filter to air dry before installing and using
again.
5. Reinstall the filter.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EC
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of defects
in both materials and workmanship for the period
lawfully stipulated starting from the date of original
purchase. Should the product develop any failure
during this period due to defective material and/or
workmanship then contact VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or
improperly maintained;
• Non-original spare parts have been used.
WWW.VONROC.COM