Installation Procedure - Toto Aimes TL626DD Manual De Instrucciones Y Del Propietario

1) Prepare the deck surface as
shown in the illustration to
the right.
2) Remove the nut, washer, and tee
fitting from the bottom of the spout
shank, then install the spout shank
through the center hole in the deck.
Align the flat portion of the spout
shank with the back edge of the
deck.
From below the deck, secure the
spout shank with the mounting
bracket and hex nuts. Reinstall the
tee fitting, washer, and nut onto the
spout shank.
3) Turn the locknut as far down the cold
valve body as possible. Unscrew the
deck adapter from the hot valve body.
Install the valve body from below the
deck, and tighten deck adapter until it
bottoms out.
Secure the valve body to the deck by
tightening the locknut and the screws.
Repeat this procedure for the hot
valve body.
4) Install the spout on the spout shank
as shown, and tighten the set screw
to secure it. Install the lift rod through
the small hole behind the spout.

INSTALLATION PROCEDURE

All Holes
1-1/4" [32mm]
Rubber Washer
& Metal Washer
4
8" [203mm] to 16" [406mm]
1-3/4" [45mm] MAX
Deck Thickness
Tee Fitting
Lock Nuts
Hex Nut
Deck Adapter
Valve Body
Spout Shank
Mounting Bracket
Spout