Getting Started; Unpacking; Preparation; Installing In The Vcr - Sony SVT-RS100 Manual De Instrucciones

Getting Started

Unpacking

Check that you have received the following items with
the Computer Interface Board SVT-RS100.
• SVT-RS100 (1)
• Fixer (1)
• Ground clip (1)
• Screw (1)

Preparation

Attach the fixer to the bottom panel of the SVT-RS100
as illustrated to fix the panel.

Installing in the VCR

1
Remove the four screws from both sides of the
VCR and remove the top panel.
4
2
Remove the screw holding the ground clip from
the VCR and keep it for later use.
3
Remove the screws (2 or 4*) holding the blank
plate on the rear panel of the VCR.
*The number of screws holding the blank plate differs
Fixer
4
Plug in the connector of the Board and place the
Board into the VCR.
Fix the Board to the rear panel of the VCR using
the screws removed in step 3.
Make sure that you use the correct type of screws.
depending on the model. The illustration below shows
a model which has four screws.
Note
Ground clip
Blank plate