WAGNER EZ-ROLLER Manual De Usario página 6

ASSEMBLY AND STORAGE
STORAGE NOTES
Proper cleaning and lubrication of certain
i
components of the EZ-Roller™ are critical to
prolonging the life of the components.
If after extended use the plunger has a tendency
to stick, apply a generous amount of petroleum
jelly located on the end of the plunger (see
Lubricating the components, step 2).
When storing the EZ-Roller™, make sure the fill
valve is pointing downward, and never store the
EZ-Roller™ with the fill tube inserted into the fill
valve.
Attention
ASSEMBLY AND STORAGE OF THE COMPONENTS
1.
Turn the locking collar as shown until the main tube slides easily
off of the plunger.
2.
Lubricate around and in between the plunger O-rings with
petroleum jelly.
3.
Re-insert the plunger back inside the main tube. Make sure the
O-rings do not twist or cut.
4.
Tighten the locking collar.
5.
Lubricate the inside of the fill valve housing on the main tube with
petroleum jelly.
6.
Clean and lubricate with petroleum jelly the indicated areas on
the roller arm.
7.
Lubricate the roller caps with petroleum jelly as shown.
Reassemble roller cover. Place back onto roller arm.
8.
Attach roller arm to head. Lock arm into place by pushing down
on the Quick-Release tab.
6
6
EN
7
1
2
3
4
5
8