SOMFY RU Basic 28 WF RTS Li-ion II Manual De Instrucciones página 21

RU Basic 28 WF RTS Li-ion II
CAUTION
• Do not use tools that could damage the drive when replacing the battery.
• Do not cut or damage the antenna cable.
1] If the drive is fixed to the tube, disassemble
the motorised product to access the self-
tapping screws or steel pop rivets (drive
wheel side) and remove them.
2] Grab the drive head and pull out the drive
by sliding it out of the motorised product
tube.
3] If necessary, offset the ring gear on the
tube to access the cruciform screws and
unscrew the drive head.
4] Remove carefully the drive head from the
tube taking care not to damage the wires
and disconnect the battery.
5] Grab and remove the used battery by
sliding it out of the tube taking care not to
damage the wires.
6] Insert and slide the new battery into the
drive tube, leaving the battery connector
accessible from the outside of the tube.
7] Connect the new battery.
8] Insert the drive head using the keying
notches on the tube taking care not to cut
off the wires.
9] Screw the motor head using the cruciform
screws to the drive tube.
➔ Restart the installation referring to Assembling
the drive-tube.
©
Copyright 2021 SOMFY ACTIVITES SA. All rights reserved.
1]
2]
3]
4]
5]
6]
7]
8]
9]
EN
21