Important! The fitting must be installed, flushed
and tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slip the fixation piece including the washer over
the threaded pins and tighten the nuts.
4. Connect the supply pipes to the angle valves;
cold right - hot left.
5. Connect the pull rod to the pop-up waste.
Large differences in pressure between the hot and
cold water supply should be balanced.
Operation
The mixer is actuated by lifting the lever head.
Swivel to the left = hot water,
swivel to the right = cold water.
Technical Data
This
mixer
series-produced
waterdimmer (flow limiter)
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Rate of flow 14003000:
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
If the continuous flow heater makes any problems
or there comes not enough water, the waterdimmer
(flow limiter 8a) located behind the mousseur must
be removed.
To adjust the hot water limiter on single lever mixers,
please see page 3.
No adjustment is necessary when using a continuous
flow water heater.
7
English
Spare parts (see page 4)
1
1.1 screw cover
2
3
4
5
6
7
8
9
10
11
Special accessories
X
XXX = Colors
000 chrome plated
with
090 chrome plated /gold plated
450 white
7 l/min 3 bars
14 l/min 3 bars
6 l/min 3 bars
max. 10 bars
1 - 5 bars
16 bars
max. 80° C
65° C
lever head
flange
nut
service set
seals
mixer ball
mixing unit cpl.
aerator cpl. (7 l/min)
aerator cpl. gold plated (7 l/min) 94980990
aerator cpl. (6 l/min)
pull rod
fixation cpl.
connection hose
special tool set
(not part of delivery)
14091XXX
94186000
94130XXX
94106000
13952000
13962000
13964000
14095000
13085000
96788000
92620XXX
94138000
94076XXX
58085000
7