Remote Control; Connection And Operation - FONESTAR MALIBU-215P Manual Del Usuario

EN
POCKET MICROPHONE
1.- Information screen.
2.- Battery holder. Use two LR-6AA alkaline batteries.
3.- Microphone input, 3.5 mm jack connector.
4.- Operation switch. It has 3 positions, ON 1, STANDBY
(centre position) and OFF. Turn it to the ON position
for operation. Set the switch to the STANDBY position
to save battery power and the microphone will turn on
immediately when the switch is turned ON.
5.- BATT LOW: operation and low battery indicator light.
When the batteries are low, the indicator light will dim
and it is advisable to change the batteries.
6.- Antenna

REMOTE CONTROL

1.- EQ: allows you to select between the different existing equalisations.
2.- : start/pause playback.
3.- CHANNEL - CH+/CH+: one press of these buttons allows you to go to the
previous/next folder.
4.- - (VOL -)/+ (VOL+): player volume controls.
5.- (PREV) / (NEXT): a short press on these buttons allows you to skip to
the previous/next audio track.
6.- 0-9: numeric buttons for automatic selection of the desired audio track.
7.- MODE: allows you to select the desired audio source.
8.- ENTER: allows you to change the play and repeat mode of the player (repeat
all, repeat folder, repeat 1 and random play).

CONNECTION AND OPERATION

Before making any connections, make sure that all equipment is switched off and disconnected from the
power supply socket.
The basic connections are as follows:
1.- Microphone inputs (MIC 1-2): connect microphones to this input. The inputs are balanced, for dynamic
microphones with XLR connector and 6.3 mm jack.
2.- Audio source, it is possible to select between line input LINE IN or the player. To use the line input,
connect an external sound source (CD player, audio player, etc.) to the input via 2 x RCA connectors
and place the LINE/PLAYER selector without pressing. Otherwise, if you wish to use the player as a
source, press the LINE/PLAYER selector and connect the device you wish to play to this module.
3.- Audio output (LINE OUT): connect the audio output signal to a recorder, amplifier, power amplifier or
other loudspeaker. Line level output signal with 2 x RCA connectors.
4.- Turn on the amplifier with the switch located at the bottom of the rear panel. You can use the equipment
powered directly from the mains or using the internal battery. If you make use of the battery when turning
on the loudspeaker, the battery indicator lights will illuminate to indicate the battery level-charge. Check
that it is charged before use.
1
1
- 4 -
3 4 5 6
2
2
3
1
4
5
2 3
6
7
8