aarke CARBONATOR PRO Manual Del Usuario página 12

EN
Cylinder gasket troubleshooting
The rubber gasket inside the Carbonator's
cylinder compartment is an important seal
between the cylinder and the machine. If the
gasket is missing, damaged, or misplaced, the
machine will not work as intended. Symptoms
of this could be:
• A leaking sound from the cylinder
compartment when pressing the Carbonator
button.
• Water droplets in the cylinder compartment
or a frozen cylinder.
• The cylinder quickly runs out of gas.
• The cylinder is leaking gas when screwed
into the machine, even when the button isn't
being pushed.
Checking the gasket
1. Lay the Carbonator on its side and unscrew
the cylinder.
2. Look into the cylinder compartment. Check
if there is a black ring around the brass pin.
If not, continue to "Replacing the gasket".
3. If there is a black ring that is damaged or
placed incorrectly, remove it and continue to
"Replacing the gasket".
Replacing the gasket
There is an extra gasket stored under the base
of the machine, underneath a sticker labeled
"Extra Gasket." Remove the sticker and take out
the extra gasket.
1
2
1. Place the new gasket on the gas cylinder.
2. Drag the Carbonator over the side of
the table.
3. Insert the cylinder and screw it in place.
When the cylinder is removed the gasket will
remain in place.
12
3